FacebookYouTubeLinkedIn

cement mill motor

3000 HP Cement Motor

After having successfully cutting coils from a stator on site four times previously, the 3,000 HP stator finally died and had to be scheduled to be rewound at a cement plant in KY. The removal of the motor is not the conventional way you think of a motor being removed, you start by removing the outside wall of the building it is in, and then sticking the boom of the crane inside the building to be able to lift the motor. standing at a safe distance from the equipment, the motor does not look all that large, but as if gets [...]

3000 HP Cement Motor2023-03-15T10:11:23-04:00

Finish Ball Mill Motor

A 1350 HP Synchronous Motor out of a cement plant in Ohio was called out to bid and Horner won that bid. This finish mill motor comes out of a cement plant in the ball mill. The ball mill is a big round pipe that is full of steel balls the size of a softball. As the pipe turns it has blades welded on the inside which carry the balls up to the top of a 16-foot diameter pipe and the balls fall to the bottom of the pipe where the rocks are. The weight of the balls smash the rock [...]

Finish Ball Mill Motor2022-01-28T15:09:16-05:00

Cement Season at Horner

It’s cement outage season in Indiana with Horner doing work in Greencastle, Louisville, Logansport, Speed, and Mitchell IN. A Central Indiana cement plant is conducting their largest Maintenance and Repair outage in 20 years. They needed to replace an entire section of both the kiln and raw mill. The company brought in a 700-ton mobile crane to the plant site requiring 78 semi loads of support to set up. The time needed for these extended kiln and mill repairs allowed the customer to do all other outage work in the same 6-week timeframe. Washington Street, Terre Haute and HMS are all [...]

Cement Season at Horner2021-02-18T18:28:09-05:00
Go to Top